Disables the SA_RESTART behavior on macOS which causes:
> Restarting of pending calls is requested by setting the SA_RESTART bit
> in sa_flags. The affected system calls include read(2), write(2),
> sendto(2), recvfrom(2), sendmsg(2) and recvmsg(2) on a communications
> channel or a slow device (such as a terminal, but not a regular file)
> and during a wait(2) or ioctl(2).
From: https://man.openbsd.org/sigaction#SA_RESTART
This being set on macOS caused a bug where read() calls to the daemon
socket were blocking after a SIGINT was received. As a result,
checkInterrupt was never reached even though the signal was received
by the signal handler thread.
On Linux, SA_RESTART is disabled by default. This probably effects
other BSDs but I don’t have the ability to test it there right now.
Starts progress on #5729.
The idea is that we should not have these default methods throwing
"unimplemented". This is a small step in that direction.
I kept `addTempRoot` because it is a no-op, rather than failure. Also,
as a practical matter, it is called all over the place, while doing
other tasks, so the downcasting would be annoying.
Maybe in the future I could move the "real" `addTempRoot` to `GcStore`,
and the existing usecases use a `tryAddTempRoot` wrapper to downcast or
do nothing, but I wasn't sure whether that was a good idea so with a
bias to less churn I didn't do it yet.
Before this change, stdout was closed after the pager exits. This is
fine for non-interactive commands where we want to exit right after
the pager exits anyways, but for interactive things (e.g. nix repl)
this breaks the output after we quit the pager.
Keep the initial stdout fd as part of RunPager, and restore it in
RunPager::~RunPager using dup2.
We can actually just load nss ourselves and call in nss to configure it
and we don't need to run a dummy query entirely to have nss load nss_dns
as a side-effect.
Signed-off-by: Arthur Gautier <baloo@superbaloo.net>
This avoids an ambiguity where the `StorePathWithOutputs { drvPath, {}
}` could mean "build `brvPath`" or "substitute `drvPath`" depending on
context.
It also brings the internals closer in line to the new CLI, by
generalizing the `Buildable` type is used there and makes that
distinction already.
In doing so, relegate `StorePathWithOutputs` to being a type just for
backwards compatibility (CLI and RPC).
Make the printing of the build logs systematically go through the
logger, and replicate the behavior of `no-build-output` by having two
different loggers (one that prints the build logs and one that doesn't)
