This also reworks the Mercurial fetcher (which was still using the
old cache interface) to have two distinct cache mappings:
* A ref-to-rev mapping, which is store-independent.
* A rev-to-store-path mapping.
Instead of relying on setup script to set output variables when
structured attributes are enabled, iterate over the values of an
outputs associative array.
See also
374fa3532e/pkgs/stdenv/generic/setup.sh (L23-L26)
Now that we have a few things identifying content address methods by
name, we should be consistent about it.
Move up the `parseHashAlgoOpt` for tidiness too.
Discussed this change for consistency's sake as part of #8876
Co-authored-by: Eelco Dolstra <edolstra@gmail.com>
This probably snuck in in a refactor using truthiness or so. The
trustedness flag was having the optional fullness checked, rather than
the actual contained trust level.
Also adds some tests.
```
m1@6876551b-255d-4cb0-af02-8a4f17b27e2e ~ % nix store ping
warning: 'nix store ping' is a deprecated alias for 'nix store info'
Store URL: daemon
Version: 2.20.4
Trusted: 0
m1@6876551b-255d-4cb0-af02-8a4f17b27e2e ~ % nix doctor
warning: 'doctor' is a deprecated alias for 'config check'
[PASS] PATH contains only one nix version.
[PASS] All profiles are gcroots.
[PASS] Client protocol matches store protocol.
[INFO] You are trusted by store uri: daemon
```
When querying all paths in a binary cache store, the path's representation
is `<hash>-x` (where `x` is the value of `MissingName`) because the .narinfo
filenames only contain the hash.
Before cc46ea1630 this worked correctly,
because the entire path info was read and the path from this
representation was printed, i.e. in the form `<hash>-<name>`. Since then
however, the direct result from `queryAllValidPaths()` was used as `path`.
Added a regression test to make sure the behavior remains correct.
I realized it was checking NAR hashes before of added objects, which
makes little sense --- we don't really care about ancillary NAR hashes.
Now, the bottom `nix store add` tests compare the CA field with a git
hash to hashes calculated by Git. This matches top `nix hash path` ones
in using git as a source of truth.
* Add regression test
* Fix 'no repo' test so it doesn't succeed if the data is still in cache
* Use git_revparse_single inside git-utils instead of reimplementing the same logic.
Currently there isn't a convenient way to check for multiline output. In
addition, these outputs will easily change and having a diff between the
expected an the actual output upon failures is convenient.
this needs a string comparison because there seems to be no other way to
get that information out of bison. usually the location info is going to
be correct (pointing at a bad token), but since EOF isn't a token as
such it'll be wrong in that this case.
this hasn't shown up much so far because a single line ending *is* a
token, so any file formatted in the usual manner (ie, ending in a line
ending) would have its EOF position reported correctly.
